| Register
Home > News > Technology corridor >

The use of Thermostatic incubator

1. Never put the Thermostatic incubator on flammable and volatile chemicals so as not to break the electronic parts.
 
2. Pay attention to protect the Thermostatic incubator paint surface affect the appearance of the box.
 
3. If abnormality, odor, smoke, etc. occur during use, please turn off the power immediately. Do not repair it blindly. Users should notify the company's repair department to have them checked and repaired.
 
4. When it is not used for a long time, the power should be cut off. It is forbidden to enter the machine in various places so as not to damage the host.
 
5. The working voltage of this electric thermostatic incubator is AC 220V, 50Hz. Before use, you must pay attention to whether the power supply voltage used is in accordance with the specified voltage, and ground the power socket and perform grounding as required.
 
6. When using electricity, avoid contact with the electrical parts of the left side of the incubator and wipe it with a damp cloth and water.
 
7. The power cord can’t be wrapped around the metal and be placed in a hot or humid place, prevent rubber aging and leakage.
 
8. The test object should not be over-squeezed in the Incubator so that the air flow can be maintained, and the heat inside the Incubator can be kept even. The bottom plate of the inner chamber is close to the electric heater, so it is not appropriate to place the test object. In the laboratory, the wind top door should be unscrewed properly in order to adjust the temperature inside the box.
 
9. When the electric Thermostatic incubator is placed in valuable strains and cultures, it should be observed and an abnormal situation should occur. Immediately cut off the power supply to avoid external or unnecessary losses.
 
10. After each use, the power must be turned off. Keep the inside and outside of the box clean and the water in the tank clean. Increase the transparency of the glass. Do not wipe the outside surface with acids, alkalis or other corrosive solutions.
 
11. The fuse tube is installed in the left side space of the incubator. When the exchange is performed, the side door must be opened and the power must be cut off.
 
12. When the equipment is not used for a long time, the power cord should be unplugged to prevent equipment damage to people. And should be run regularly (usually in the first quarter) according to the conditions of use for 2-3 days in order to drive off the moisture of the electrical parts to avoid damage to the device.

  • E-mail : kenton@kentonchina.com
  • Pre-sale
  • 0086-020-36246586
  • 0086-020-36247961
  • 0086-020-36246649
  • 0086-020-36246650
  • 0086-020-36246651
  • After-sales
  • 0086-18688422996