CO2 incubator touch screen time parameter setting

Touch screen CO2 incubator than the traditional LCD screen more functions, there are many users feedback that the setting is more difficult to master. In fact, as long as the setting method is clear, the operation is actually very simple. Now teach you the time parameter settings, first look at the operating interface:

Name		Initial value (setting range)
Timer	Year, month, day, hour, minute When the current time at start-up is less than that time, the system enters the appointment waiting state until the current time is greater than or equal to that time, when the system enters the running state. When the current time at start-up is greater than or equal to that time, the system enters the running state.	December 1, 2010 at 0:0 pm
Timing methods	Start timing: the system can jump directly from the running state to the timing state. Constant temperature timing: when the system is running, and when "main temperature set value - constant temperature timing deviation ≤ main temperature measured value ≤ main temperature set value + constant temperature timing deviation", the system can enter the timing state.	Start Timer
Constant temperature timing deviation	If the measured temperature value differs from the set value within this parameter, the system goes from "running" to "timing" and starts timing.	(0～10.0℃) 0.5
Alarm	A beep will sound at the end of the run to indicate the time. Note: 0 means continuous beeping.	(0～300s) 60
Lighting timer	Automatic switch-off time after lighting has been turned on. (System settings can be set with or without the lighting function) Note: 0 means the lighting must be turned off manually.	(0～9999min) 1

Note: Make sure to follow the instruction for each section carefully.

In the previous：Definition of the keys on the proportional CO2 oveen panel The next article：Structure and principle of Environmental chamber